Would it do any good to copy the /opt/arduino-1.8.x/hardware/tools folder from x86 Ubuntu unto the GL-AR300M-Ext? How would I use them?Īnother option is to capitalize on the similarity to the Yun. If someone could post a useable OPKG makefile, or better an actual OPKG for the CLI Teensy loader I would greatly appreciate it. QCA9531 very similar to the 9331 in a YUN. I have used menuConfig to build firmware, but never built a new package from scratch. But how do I do that? I am very newb with the openWRT build system and makefiles in general. My first thought was to put CLI Teensy loader on the GL-AR300M-Ext router. It doesn't seem to make much sense to install Arduino and Teensyduino on the host Linux computer(GL-AR300M-Ext router) to which the Teensy is attached by USB. I suspect your answers will also help pictographer and others in a similar bind.

I do not know how to do that and am seeking advice. My question involves how to repeatedly reprogram the Teensy in situ from a remote computer on the network. The Teensy can be plugged into the USB host port on the travel router.

Soon, the Teensy will support several additional sensors and be used for a variety of experiments. But for now they are both connected to the Teensy 3.2 who's display provides local output(pseudo terminal) for troubleshooting. Eventually(once I figure out how to stop them from occasionally spewing garbage), they will be connected together. The robot vacuum has a 3.3v serial console, so does the router. My project is to wirelessly communicate with a Neato Botvac85(link has relevant pictures only, not relevant code AFAIK) and Teensy 3.2 via GL-AR300M-Ext wireless travel router, all mounted on the robot vacuum.

Openwrt usb serial ftdi